Energy saving - How to calculate the cost savings

-
The electric motor is usually the prime mover of the air compressors. Therefore, to save the energy of compressed air system is to save the energy consumption of the electric motor.

Energy saving of the electric motor can be written as shown in the following formula







Thus,

Cost savings = Energy savings x Unit cost of energy

Comments

Post a Comment

Popular posts from this blog

Air compressors work - Compression process

-
Image
To understand how to save the energy in compressed air system , it is useful to start with theory background of how the air compressors work and how the energy is consumed. As we know from Thermodynamic principle that the compressor work is, where: rev = reversible in = input Our objective is to minimize the air compressor work that means to approach the reversible process i.e. minimize the friction, and turbulence Practical way to do this is to make v (specific volume) small by maintaining T (temperature) at low temperature during compression because v a T. In other words, to reduce the work input to a compressor, air should be cooled as it is compressed. Effect of Cooling Isentropic process: No cooling during compression Polytropic process: Involve some cooling Isothermal process: Involve maximum cooling Which process yields the minimum required compressor work? Let's consider the following equations of each process. Assumptions: All three processes are executed between the same...
Read more

Tips to Reduce Compressed Air System Pressure Drops

-
Ask a Question: What causes pressure drops in my compressed air system and how can I reduce them? Answer: Pressure drop can become a compressed air system problem that steals production time and money. What causes pressure drops? Any type of obstruction, restriction, or roughness in the system will cause resistance to air flow and cause pressure drop. In the distribution system, the highest pressure drops usually are found at the points-of-use, including undersized or leaking hoses, tubes, disconnects, filters, regulators and lubricators (FRLs). On the supply side of the system, air/lubricant separators, aftercoolers, moisture separators, dryers and filters can be the main items causing significant pressure drops. The maximum pressure drop from the supply side to the points-of-use will occur when the compressed air flow rate and temperature are highest. Your Compressed Air System components should be selected based upon these conditions and the manufacturer of each component should b...
Read more